Zhengzhou Risesun Electroheat Co., Ltd. Company Logo Zhengzhou Risesun Electroheat Co., Ltd.
5 1

Installation of MoSi2 heating element

Contact Now* Send an Inquiry to this supplier.
or
Start Order * Name your price

Contact us

Zhengzhou Risesun Electroheat Co., Ltd.
[China]

Address
Building 5, Zone A, Standard Workshops, Industrial Cluster Area, Dengfeng, Henan, China Zhengzhou Henan
Phone
86-371-62705299
Contact name
Yang Xuehao

Quick Information

  • Brand Name: Risesun Hotbar
  • Place of Origin: China

Description

1. Vertically hanging***
Under normal temperature, MoSi2 element is very brittleness, while under high temperature it is plasticity. So, the better way for installation lf the U- type element is to hang it vertically, to the furnace top through the support clamping chuck H. The aim of such way is to avoid putting the mechanical stress directly to the element heat-generating end, or the element will easily break.*****

2. Support clamping chuck***
Support clamping chucks are applied to ?9/18 and ?6/12 two kinds of elements respectively. The whole weight of the element is supported by the support clamping chuck and the position of the element is also determined by it. Therefore, it must be installed carefully to assure that the element is vertically hung. In order to prevent the element from being over heated locally, the taper part of the element lower end must put into the furnace chamber.*****

3. Wire clip***
The wire connection clamp connecting MoSi2 element is made of aluminum woven wire or multi-layer aluminum foil. The steel plate outside it only acts as a clamp and isn't used for electric conduction. For ?6/12 element, single rowing wire is used, and for ?9/18 element, double-rowing wire is used. The end of the lead wire should be a little larger than the linear distance between the element and bus.
When the element is installed, the thread fixing the wire clip shouldn't be screwed too much at one time, it can be tightened when the element rises to high temperature, as the element has some plastic and isn't easily broken. The temperature of the wire clip generally shouldn't be higher than 200?. Therefore, the contact voltage between the clip wire and element should be lowered to 0.1V. In order to avoid that the radiation heat is conducted to the clip, the distance between the lower end of the clip and upper surface of the through brick should not less then 50mm. Generally for ?6/12 element, 170A should not be used protractedly and for ?9/18 one, 300A shouldn't used, either.
 


Product Image

  • Installation of MoSi2 heating element image

Related products from premium suppliers on EC21

Send an Inquiry to this supplier

Send an Inquiry to this supplier
* From
  To Yang Xuehao
Zhengzhou Risesun Electroheat Co., Ltd.
* Buying Product
- Please enter your specific buying item.
e.g. 42 inch LCD TV, leather executive chair
Category : Other Heaters
* Message

Use English only Max. 2000 characters. (Min. 20)

Send
EC21.com does not guarantee the validity of product information or the credentials of sellers.